Hydraulic Metal Hose Related Information

Functional Characteristics, Working Scope, Technical Requirements:

YKCX-400B hydraulic metal hose forming machine (U-shaped wave)

  1. Features:

YKCX-400B hydraulic metal hose forming machine uses emulsion as the drum wave medium. Under the joint action of the hydraulic control system and the fixed-length mold, the welded single-layer or double-layer stainless steel billet is automatically set by the positioning, drum wave, and forming process. The single wave is continuously formed into an annular corrugated tube of corresponding diameter.

YKCX-400B hydraulic metal hose forming machine adopts PLC programmable control mode, and can be controlled manually and automatically.

The system is equipped with a program for hydraulic feeding, automatic feeding of straight side sections, and two high and low waves at each end to change the wave height.

A positioning device for adjusting the opening position of the front and rear molds during drum wave (cylinder control dead block structure) is installed, supplemented by a proximity switch to ensure consistent waveforms.

  1. Working range and technical parameters:
  2. Formable inner diameter range of bellows: DN80-DN426mm.
  3. The corresponding relationship between its inner diameter and wall thickness is as follows:
    DN DN80 DN100 DN125 DN150 DN200 DN250 DN300 DN350 DN400
    ID DN89 DN108 DN133 DN159 DN219 DN273 DN325 DN377 DN426
    Single Wall 0.6 0.7 0.8 0.9 1 1.2 1.5 1.7 2
    Thickness
    Double Wall 0.4*2 0.5*2 0.6*2 0.7*2 0.8*2 1.0*2 1.0*2 1.2*2 1.2*2

Note: The data listed in the table refers to the maximum allowable molding.

  1. Formable bellows length range: ≤7000mm.

(3). YKCX (D)-400 into a single wave hydraulic metal hose forming machine (U-shaped wave)

  1. Features:

YKCX (D)-400 into a single wave hydraulic metal hose forming machine uses emulsion as the drum wave medium. Under the joint action of the hydraulic control system and the fixed-length mold, the formed bellows are fitted with flange rings to perform single-wave drum wave forming at the end. (The two ends are made by the same process)

YKCX (D)-400 into a single wave hydraulic metal hose forming machine adopts PLC programmable control mode, and can be controlled manually and automatically.

  1. Working range and technical parameters:
  2. Formable inner diameter range of hoses: Tefal specifications 300A, 350A, 400A.
  3. Wall thickness range of formable hoses: δ=0.8-1.0mm.
  4. After single-wave forming, ensure that the end flange rotates freely between the waveforms on the light pipe.

(4). YDBCX-400 single wave parallel wave hydraulic forming machine

  1. Features:

Under the joint action of the hydraulic control system and the fixed-length mold, the equipment forms the wavelet single wave and wave formed on the outside of the flange ring. (The two ends are made by the same process)

The main body of the equipment is a four-post frame structure, and its control system adopts PLC programmable control mode, which can be controlled manually and automatically.

  1. Working range and technical parameters:
  2. Formable inner diameter range of hoses: Tefal specifications 300A, 350A, 400A;
  3. Wall thickness range of formable hoses: δ=0.8-1.0mm.

Leave a Reply

Your email address will not be published. Required fields are marked *